Watch all my videos on YouTube! Building a box into the kitchen cabinet, that will hold the induction cooktop. Finishing it off with some Formica.
Campervan Kitchen Ideas
Watch all my videos on YouTube! Building kitchen cabinets and fitting them in the van. Finding out if it all works or that I have to make adjustments in the design. First time inside the van standing in the shower pan, calculating where the shower head
Neodymium Magnets In The Murphy Bed Legs
I’m putting the finishing touches on the Murphy bed and added two strong magnets to each leg. The legs of the fold down bed have to be secured in two places. When the bed is pulled down, the legs should be extended and held in a 90 degree position and not over-extend.
Picture Frame & Canvas
Watch all my videos on YouTube! In an effort to finish the driver’s side of the interior, I prepared a molding for the bottom of the Murphy bed and started to replace the fill dish and hoses at the fresh water tank. The wardrobe side wall also got a Formica finish. In addition, I started… Continue reading Picture Frame & Canvas
Murphy Bed Legs
Watch all my videos on YouTube! In the coming weeks, I’ll be finishing the Murphy bed. Today I move the bed back into the van; it’s time to take some final measurements and add the legs. I use a similar pivot mechanism on both legs and some magnets to keep the legs in place when… Continue reading Murphy Bed Legs
Fresh Water Tank Dump Valve
Mobile DVR, Wiring & Cabinets
Cabinets, Lights & Loose Ends
RV Cabinet Hinges & Pushbutton Latches
Shower-In-A-Drawer – Part Four
Watch all my videos on YouTube! The inside and outside of the shower drawer are getting three coats of polyurethane, the top of the box is finished off with a Maple edge. And when the cabinets are built, I have a novel solution for the shower head.