Subfloor installation

One heavy piece of ½” plywood. Weight is always a consideration, both as in maximum payload and as in fuel economy. I estimate the weight of most items that I install and keep a total as a reminder. As for the plywood, I’ll need another sheet to finish the job.

advertisement

 

015To size the plywood, I first align it and extend the lines with a carpenters square. In this case, I first drill a hole with a ¾” forstner bit where the corners of the wheel casing are going to be, followed by the saw cuts, to remove the cut-out. I angled the cuts to follow the sloop of the side of the wheel casing.

016 017 018

 

advertisement

 

 

019Second step is to fit the ply to the step-in at the side doors.

 

 

020 021Beginners luck: an exact fit.

 

 

The ply will be fastened to the metal floor with a dozen or so metal tap screws.

sponsors

Leave a comment

Your email address will not be published. Required fields are marked *